Other Gear > Reel to Reel Tape
Technics RS 1500 power cord
Doc B.:
Alignment tapes have been requested from the duping lab. Albums have been flying out of here so far this year and they may need a week or three to fit alignment tapes into the production schedule.
ALEXZ:
--- Quote from: Doc B. on February 22, 2015, 05:03:10 PM ---That's weird, as I was putting in custom panels cut for an IEC to replace the stock power inlet and I don't recall a problem. But there were also a few different power inlet wiring schemes used. on those decks.
--- End quote ---
If Technics chassis is grounded via power cord, outbord repro is grounded via power cord and Technics chassis is connected via ground wire to a ground post on the repro , that creates ground loop and a lot of hum. Don't ask how i know...
Navigation
[0] Message Index
[*] Previous page
Go to full version