Bottlehead Forum

General Category => General Discussion => Topic started by: wylymon on December 28, 2009, 01:10:57 PM

Title: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: wylymon on December 28, 2009, 01:10:57 PM

Gentlefolk,

My Linn and Eros are all a twitter in anticipation!

Thanks!

James
Guilford, IN

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: wylymon on January 30, 2010, 09:35:02 PM

This thread has been active for 1 month and still no reply.......disappointed.

Thanks,


James

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: Grainger49 on January 31, 2010, 05:23:49 AM

You might PM the parties?

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: Bas Horneman on February 01, 2010, 02:07:23 AM

Some advice if I may. The way you posted does not readily invite answers. I.e. putting the question in the header. But without a question mark. It looks like you are announcing something.

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: Grainger49 on February 01, 2010, 02:26:19 AM

I just saw that it has been read 188 times.  I think Bas Horneman may be right.  I knew it was a question but it may not be obvious to everyone.  It should be.

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: Doc B. on February 01, 2010, 05:08:57 AM

I think I answered this question very recently, but perhaps that was in a PM to someone. The initial attempt at a shield can was quiet, but not quiet enough. I hope to be talking to a supplier of a more robust shielding setup soon. It's been quite busy the past couple of months and I have been spread a bit thin.

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: wylymon on February 01, 2010, 07:03:47 AM

Thanks guys for your responses! I will be more careful with my posts in the future. Good luck Dan with this project.
IF anything good came from my post, at least we have an indicator of interest.

Title: Re: Status of Bottlehead/Magnaquest phono stepup transformer
Post by: Doc B. on February 01, 2010, 01:41:51 PM

I ordered some material to try for additional shielding today. I have an idea for a method that might allow us to do a small prototype run without having to order several thousand dollars worth of shield cans.