Bottlehead Kits > BeePre

BeePre2 Output Upgrade Impressions

<< < (3/3)

sl-15:
Sounds like matching is not necessary then, thanks Paul.

Brissie:
Hi Sam,

I hope you're still following this old thread.

Thank you for posting your experience with the BeePre2 output upgrade.
You mentioned you upgraded the 10uF caps with ODAM capacitors.
The output upgrade adds two additional 10uF caps on each channel.
I assume you only swapped the 4 Daytons in the signal path for ODAM capacitors, or did you do all 6?
Was there a noticeable improvement?

Thanks, Steve

Paul Birkeland:
When I build these with ODAMs, I do not use one for the -Ve leg of the XLR jack.

Navigation

[0] Message Index

[*] Previous page