Noob Stuck on Heater Circuit [resolved]

thebellowsfold · 919

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline thebellowsfold

  • Newbie
  • *
    • Posts: 4
on: December 07, 2018, 03:13:44 AM
Hello.  I am a complete newbie here.  I have been doing well up until getting the heaters to glow on my build.  The previous two checks in the instructions went well.  I have ran through the instructions and checked the location of all my wires twice but obviously I am missing something.  Any tips would be greatly appreciated. 
« Last Edit: December 09, 2018, 02:08:03 PM by Paul Birkeland »


Offline kgoss

  • Sr. Member
  • ****
    • Posts: 328
Reply #1 on: December 07, 2018, 03:24:10 AM
Is the fuse installed?  It's easy to overlook that step.
If it is then the fastest and easiest resolution from BH support happens when you post pictures

Ken Goss

Offline thebellowsfold

  • Newbie
  • *
    • Posts: 4
Reply #2 on: December 08, 2018, 03:56:31 AM
Hello.    Thanks for the reply.  I did check and make sure the fuse is in and not burnt.  I have attached a photo.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19395
Reply #3 on: December 08, 2018, 07:46:38 AM
Measure the DC voltage between H4 and H5 (preferably with no tubes installed).

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline thebellowsfold

  • Newbie
  • *
    • Posts: 4
Reply #4 on: December 08, 2018, 05:33:20 PM
Hello.

   Thank you.  When I went to check what you asked I found something I missed earlier.  The black wire on the "N" terminal on the power socket had broken off somewhere along the line.  Soldered it up and got my glow.  Thanks!!!!   


 
Quote from: Paul Birkeland on December 08, 2018, 07:46:38 AM
Measure the DC voltage between H4 and H5 (preferably with no tubes installed).

-PB


Pages: 1   Go Up
« previous next »