Other Gear > Speakers

3-D printed speaker

<< < (2/2)

debk:

Thanks!
The sides were printed in a different color

caffeinator:
Hi Debk,

Thank you for the info - that color looks great and an attractive contrast with the black.

Turns out I have a few NOS Radio Shack 40-1197's in my stash...they were rumored, back in the day, to be identical to the FE-103, and thus a bargain-basement knockoff, though the similarities may be just the basket and frame. Good luck for me in any event, since that may mean they'd drop in to the FE-103-sized trim rings, and be a plug-n-play.

I'm printing a trim ring now to check for fit. Thanks again for the inspiration!

4krowme:
  I just ordered a #D printed gear for my lawn tractor. One question that I asked was what actual material is it made from. Turns out to be Nylon 12, whatever that is. Even though you supplied the printing material used, can you describe if it seems to be a softer type of material or harder? And I bet there is a lot of material used in just one cabinet. Overall, I bet that the cost is worth it, but am a bit curious about that as well.

Navigation

[0] Message Index

[*] Previous page