Bottlehead Kits > Kaiju Stereo 300B amp
Fuse blown during use
Paul Birkeland:
I would suggest posting photos of the area around that terminal strip.
I have never had a new capacitor that wasn't good right out of the box.
-PB
fullheadofnothing:
What value fuse are you using?
slm:
Ok So next attempt :(
The fuses are 1.5 amp slow blow
I have completely rebuilt the voltage doubler - new caps new diodes , new resistors new tag strip.
Still blowing fuses
Have taken photos during the ( 4th ) rebuild as I add the diodes and the caps . I also rewired the heater supplies just in case .
Without the voltage doubler attached the fuse is fine the secondaries on the transformer read a little high but otherwise as expected . With the doubler in place the fuse blows immediately . it is not attached to the rest of the circuit except the ground wire . I cant see a mistake .
Paul Birkeland:
Can you double check the AC voltage on the high voltage terminals on the power transformer without the diode attached? (See bottom of page 33)
-PB
Navigation
[0] Message Index
[*] Previous page
Go to full version