Solved: Failing Final Voltage Check on Stock Crack

Macron · 691

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Macron

  • Newbie
  • *
    • Posts: 3
on: March 05, 2020, 04:41:30 PM
I recently finished building the stock crack and passed the resistance check and now am onto passing the voltage check. All voltages are correct except for terminal 1 and 7 which are 150V. I checked the LED connections at a3 ad a8 and get 1.5V for both of them, with both LEDs turning on. One thing I noticed is the 10k resistors being insanely hot to touch. Could anyone give trouble shooting advice? Attached are the voltages at each terminal and a picture of the wiring.


1 150
2 167
3 0
4 167
5 63
6 0
7 149
8 0
9 91
10 0
« Last Edit: March 06, 2020, 10:03:24 AM by Macron »


Offline oguinn

  • Sr. Member
  • ****
    • Posts: 895
Reply #1 on: March 05, 2020, 04:58:31 PM
I re-read your post and am retracting mine as a result. I need more sleep.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball

Offline diynewbie

  • Full Member
  • ***
    • Posts: 68
Reply #2 on: March 06, 2020, 12:45:42 AM
For starters, the red wire from A6 should go to T1 not T5.  Wiser folks will provide more incite.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19395
Reply #3 on: March 06, 2020, 04:39:42 AM
Quote from: diynewbie on March 06, 2020, 12:45:42 AM
For starters, the red wire from A6 should go to T1 not T5.  Wiser folks will provide more incite.
That's about the long and the short of it.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Macron

  • Newbie
  • *
    • Posts: 3
Reply #4 on: March 06, 2020, 10:03:09 AM
Solved! Thank you so much guys!


Pages: 1   Go Up
« previous next »