Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Smash => Topic started by: Alonzo on February 09, 2015, 06:19:35 PM
-
Will the attenuator upgrade for the Smash be out soon? Can I just drop a Submissive into it? Or will there be large changes to the Smash to make it fit?
Thanks,
Alonzo
-
The attenuator for Smash will use different resistor values than Submissive. We're focusing our energy on getting the first run of DACs completed at the moment, and we will probably tackle the attenuator upgrade kit for Smash in the spring.
-
Will there be an attenuator upgrade for Stereomour as well?
-
Smash is all complete, Smash up and Smash quiet installed. Think I'm done with this one...
One error in the instructions: on page 16, last step. Writing has you connect to the fine switch while the picture connects to the coarse switch. I followed the picture.