Bottlehead Forum

Bottlehead Kits => Stereomour II => Topic started by: Jay on December 10, 2016, 11:56:09 AM

Title: stereomourII shunt regulator assembly question
Post by: Jay on December 10, 2016, 11:56:09 AM

I'm getting a little confused.  In the StereomourII shunt regulator manual on page 19, it says "Attach and solder the red wire connected to IA on the
Shunt Regulator board to 27U."  On page 20, it says "Attach and solder the red wire connected to IA on the Shunt Regulator board to 34U."  I assume the instruction on page 20 should have said to connect the red wire from IB to 34U.  Is that correct?

Many thanks,
Jay

Title: Re: stereomourII shunt regulator assembly question
Post by: Sugar Man on December 11, 2016, 05:26:39 AM

Yes, that is a typo.  Zooming in on the picture you can see IB and I just double-checked mine.

Title: Re: stereomourII shunt regulator assembly question
Post by: Jay on December 11, 2016, 06:40:03 AM

Thanks Mike