Speedball Voltage Check Short?

[lickitysplit09]

Hi Bottlehead members,

I recently did my speedball upgrade but had some troubles at the end of my build. I believe I shorted the LED at pin A8 while I was doing my voltage check. Please see below the voltages while I was doing my initial voltage check and afterward to see if you can help identify possible causes. Thanks in advance for the help!


While:
Terminal   
1   93.6
2   167
3   0
4   167
5   92
6   0
7   111
8   0
9   110
10   0
11   0
12   0
13   167
14   0
15   187
20   0
21   didn't measure
A1    88.3
A2    0
A3    1.5
A4    0
A5    0
A6    81
A7    0
A8    X


After:
Terminal   
1   167
2   172
3   0
4   172
5   92
6   0
7   164
8   0
9   112
10   0
11   0
12   0
13   172
14   0
15   190
20   0
21   210
A1    89.5
A2    0
A3    1.5
A4    0
A5    0
A6    167
A7    0
A8    15.8
A9    0
B1    167
B2    172
B3    165
B4    88
B5    172
B6    111
B7    0
B8    0

[Paul Birkeland]

Yes, it looks like you damaged an LED.

FWIW, if they are glowing, there is 1.5V across them.  We have removed this voltage check entirely from the newest revision of the Crack manual. 

[lickitysplit09]

Thanks for the help. Is there a way I can order this through Bottlehead? I am a local in Bellevue.

[Paul Birkeland]

You can e-mail replacementparts(at)bottlehead(dot)com