Bottlehead Forum
General Category => General Discussion => Topic started by: ALL212 on March 04, 2023, 07:46:02 AM
-
I know there might be a few R2R folk hanging around in here and I need some advice.
My A77 functions well but after attempting to clean the capstan roller it got very soft. The machine probably needs a pro to go over it. Take up is bad as I don’t think it’s pulling hard enough or too much tension on the feed side.
Are there any places to send this for a tune up or repair?
Thanks,
Aaron
-
Try JM Technical Arts
-
Thank you!