Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Quickie => Topic started by: tominredbank on March 22, 2014, 03:12:38 PM

Title: new quickie, new member
Post by: tominredbank on March 22, 2014, 03:12:38 PM

Hello all ! I just ordered my Quickie pre. I want to begin ordering my upgrade parts list and need some greatly appreciated help. I know the film caps are 2.2 uf but can you tell me value of the 2 electrolytic, the 2 resistors and the volume pot? Thanks, tom

Title: Re: new quickie, new member
Post by: mcandmar on March 22, 2014, 04:58:16 PM

Lytic is 150uf, i think anything over 47uf will do. Resistors are already Dales, and the Pots a 100k.

Enjoy!

Title: Re: new quickie, new member
Post by: Paul Birkeland on March 22, 2014, 08:12:31 PM

We generally recommend building the kit stock first, as this gives us the greatest opportunity to offer the best possible technical support.

After getting your kit up and running, it is then much easier to swap parts out with greater confidence.

-PB

Title: Re: new quickie, new member
Post by: Grainger49 on March 23, 2014, 03:49:27 AM

The circuit of the Quickie is well laid out and isn't at all crowded.  So modifications after building are very straightforward. 

Title: Re: new quickie, new member
Post by: tominredbank on March 23, 2014, 08:48:22 AM

Thanks guys,, I was planning to assemble the whole Quickie and give it a good listen before modding anything but I just wanted to find the resistor values and so on so I can order now to have them on hand when the time comes.