speedball upgrade voltage check issue

sruo · 3538

« previous next »
Pages: 1 2   Go Down

0 Members and 1 Guest are viewing this topic.

Offline sruo

  • Newbie
  • *
    • Posts: 9
Reply #15 on: June 08, 2013, 05:48:34 AM
Quote from: Paul Joppa on June 07, 2013, 08:33:36 PM
At A8 - bad LED, or backwards LED, or bad LED solder joint.

Before the upgrade, A8 was lighted up just slightly compare to A3.
Banded side toward center as instructed.
Not sure if bad solder joint is the problem here as the Crack works for one week before the upgrade.

Thanks.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19417
Reply #16 on: June 08, 2013, 04:29:36 PM
I have ~50 12AU7's, and I live pretty close to you (Maple Valley/Renton). 

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline sruo

  • Newbie
  • *
    • Posts: 9
Reply #17 on: June 08, 2013, 05:06:57 PM
Quote from: Caucasian Blackplate on June 08, 2013, 04:29:36 PM
I have ~50 12AU7's, and I live pretty close to you (Maple Valley/Renton). 

-PB
Could I swing by late afternoon tomorrow, say after 4:30?
Feel free to send me via email [email protected] if you are available.

Thanks.


Pages: 1 2   Go Up
« previous next »