stereomour 2A3's not glowing

[Paul Birkeland]

Yes, that part will work.

-PB

[azrockitman]

thanks!

[azrockitman]

I've removed the old LM431 shunt regulator and have installed and soldered the new one.  I have continuity between the two outside pins now when checking (there is no solder bridge....there is no continuity between either of the two outside pins and the center pin).  That's true for both the new replaced one and the other one on the other side of the board.  (there was no continuity on the outside pins prior to install)  Is this correct/ok, as designed?
Thanks

[Paul Birkeland]

Yes, the two outside pins are wired together with the black jumpers on the PC board.

-PB

[azrockitman]

Gotcha.  Thanks