Bottlehead Forum
Bottlehead Kits => Eros Phono => Topic started by: Tom-s on May 15, 2021, 06:05:00 AM
-
Is it ok to use a similar tube socket / cover on the 12AU7 as are already in place for the other tubes?
Or would this introduce unwanted hum?
-
Yes, you can put a shield over it if you like. The 12AU7 in the Eros runs pretty hot and doesn't otherwise benefit from the cover, so we don't use one there.
-
You can use an IERC tube cooler. I use these on all of the tubes that can fit them. They work and theoretically extend tube life by lowering the operating temperature. Mostly I use them because I like the way they look :)
-
Yes, if you use an IERC tube shield on a socket without the bayonet base it will only be serving as a cooler, not a shield. It is designed to work with a bayonet base and needs to make electrical contact with the chassis thru the base to be effective as a shield.
-
Thanks for all the replies as always.
During assembly this plan was scrapped. Unfortunately the covers that originally came with the Mainline (the one i planned to use as a fourth), were a different build from the ones provided with the Eros.
So. No cover today.
Awkward angled picture attached.
-
It looks great! Enjoy!
-
The plate finish looks.
I gotta' say the vents around the tube sockets and the RCA jacks on the 2 really make the kit look as premium as it is.
Karl
-
That is "looks great".
Karl
-
I gotta' say the vents around the tube sockets and the RCA jacks on the 2 really make the kit look as premium as it is.
I couldn’t agree more. These would look good on every Bottlehead kit.
It looks great! Enjoy!
Thanks! I do enjoy the build of all Bottlehead kits. Last few weekends I worked on some Cracks.
I cannot listen to the Eros just yet. Will finish it later this week.