Bottlehead Kits > Mainline

Voltage check issue / page 52 / 6.3vDC reading [resolved]

(1/2) > >>

Souter:
Hi, I'm getting a reading of 11.5v when testing the 6.3v solder pads.
The 275v reading is fine.

Could this be a dodgy solder?

Thanks in advance for any help.

Paul Birkeland:
I would double check that the 124 and 499 ohm resistors are in the correct spots, then add a little more solder and quite a bit more heat.

Souter:
Hi Paul, thanks for your advice
After re-soldering the resistors I’m now getting the correct reading.
Much appreciated.

N72826:
Hello, I am having the same issue. I have tried resoldering the 124 and 499 ohm resistors as well as every other pad on the board. I receive a reading of 12.1 on the 6.3vDC solder pads while the 275v solder pads are within the expected range.

Paul Birkeland:
Are you 100% positive that the resistors are the correct values?

Navigation

[0] Message Index

[#] Next page