Tube Check

Toys4Boys · 1802

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Toys4Boys

  • Full Member
  • ***
    • Posts: 77
on: September 26, 2023, 05:34:57 AM
The manual indicates that it can be difficult to see the EF86 tubes glow and I didn't when I tested the tubes as per the manual, pg. 44. I metered the plus/minus and it was 6.3V, if memory serves. I am working on the assumption that if the tubes are getting the proper voltage at this early stage that they are probably fine?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19391
Reply #1 on: September 26, 2023, 05:54:54 AM
If you measured the voltage at pins 4 and 5 on the EF86 socket and saw about 6V between them, that would be sufficient.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Toys4Boys

  • Full Member
  • ***
    • Posts: 77
Reply #2 on: September 26, 2023, 08:30:23 AM
Thank you Paul.


Pages: 1   Go Up
« previous next »