Bottlehead Forum

Bottlehead Kits => Reduction => Legacy Kit Products => Integration => Topic started by: pjnestor on January 18, 2014, 11:28:00 AM

Title: lost a channel with integration [solved]
Post by: pjnestor on January 18, 2014, 11:28:00 AM

Hi,

I am working on the integration upgrade.  Had no problem with the shunt regulator, but on the B side C4S board, I have 0 volts at terminal 31 and the diodes do not light up on that side.  The A side lights up fine.  I've double checked the board and connections, but don't see any obvious mistakes.  Any suggestions where to look.

Pat

Title: Re: lost a channel with integration
Post by: Paul Birkeland on January 18, 2014, 12:45:54 PM

Generally this is an issue with the center leg of the MJE-350 not being heated up enough during soldering.

-PB

Title: Re: lost a channel with integration
Post by: pjnestor on January 23, 2014, 05:17:17 PM

Thanks paul, that did the trick.  Sounds great