Bottlehead Kits > Integration

Errors in manual

(1/2) > >>

ffivaz:
On page 16 of the manual, top, I think the sentence should read 29U and not 30U. The picture is correct.

On page 19, the black wire is too short if cut precisely at 57mm (2 1/4 inches). 65mm, about 2 1/2 inches is better (and picture shows side holes, not middle as stated in the text).

BTW, I finished my integration last night and it sounds so good. The Denon DL-110 is a high output MC, but was clearly not high enough for the stock reduction (around 2 mV). Now with the Integration, everything sounds much more dynamic. Thanks Bottlehead!

tubedog:
So should the black wire be soldered to the middle holes of bA/bB, as written on the page,
or to the inner holes of bA/bB as in the picture?

ffivaz:
It doesn't matter, the three holes are connected. At the end of the build, on the bA side, you'll have two wires connected and only one on the bB side.
Best wishes, Fabien

Chris65:
Some further errors, although just editorial items:

Pg 2 Table of Contents - is for the Reduction, not the Integration.
Pg 23 Voltage Checks - says for Shunt Regulator, should be for C4S, and bottom paragraph is copied from the Shunt Regulator check page which says -partial upgrade', which of course by this point is the 'full upgrade'.

Grainger49:
Chris,

Here is a thought.  Check how loose the #4 is in the hole first then drag your #4 screws to a hardware store, or whatever passes for one there.  See if there is a metric screw about the same size. 

Navigation

[0] Message Index

[#] Next page