Bottlehead Kits > Integration
lost a channel with integration [solved]
(1/1)
pjnestor:
Hi,
I am working on the integration upgrade. Had no problem with the shunt regulator, but on the B side C4S board, I have 0 volts at terminal 31 and the diodes do not light up on that side. The A side lights up fine. I've double checked the board and connections, but don't see any obvious mistakes. Any suggestions where to look.
Pat
Paul Birkeland:
Generally this is an issue with the center leg of the MJE-350 not being heated up enough during soldering.
-PB
pjnestor:
Thanks paul, that did the trick. Sounds great
Navigation
[0] Message Index
Go to full version