Bottlehead Forum
Bottlehead Kits => BeePre => Topic started by: hpleung on February 17, 2024, 10:31:36 AM
-
Almost all resistance checks completed.
However
Terminal 8 to Terminal 10 measured 0L for me. It is supposed to measure 20K ohm
Similarly Terminal 8 to Terminal 15 measures 0L. It is also supposed to measure 20k ohm.
I dont see any “start low and riseâ€; it stays 0L which seems to indicate i am missing a wire.
Any pointer on where i should look?
-
There's a cap there, you're looking for a reading of 20K+ Ohms, which is what you have.
-
Thank you.