Bottlehead Forum

Bottlehead Kits => BeePre => Topic started by: denteom on May 06, 2023, 03:23:05 AM

Title: Warm up time
Post by: denteom on May 06, 2023, 03:23:05 AM

My Beepre 2 so far working fine, but noticed some quirks, Does the XLR need a longer warm up time before using it?  It sounded weird sound was softer on one speaker, kinda distorted on the other.  So I switched to the single ended and it sounded fine.  Then I decided hooking the XLR out to my headphone amp, so far sounding fine (I used it after a 25 minutes start up.
Haven't put XLR back to the power amps, but I suspect warm up time is needed.

What are your thoughts on this?

Title: Re: Warm up time
Post by: Paul Birkeland on May 06, 2023, 12:05:40 PM

The warmup time is identical between the balanced and unbalanced output.  I would definitely take a look at the solder joints in that area if you have uneven performance between channels that doesn't exist from the unbalanaced outputs.