Bottlehead Forum

Bottlehead Kits => Kaiju Stereo 300B amp => Topic started by: bombay317 on February 15, 2018, 05:11:56 PM

Title: Kaiju Build Done
Post by: bombay317 on February 15, 2018, 05:11:56 PM

I finished my build.  Everything is working, but I plan on doing some nerdy things to it :)

It was a lot of fun so far and took 22 hours to build.  I build the DC filament but have not installed it yet into the system.

If I can find the time I am going to make a Bode diagram of this amp to share with everyone.

Title: Re: Kaiju Build Done
Post by: Doc B. on February 15, 2018, 06:15:17 PM

Looking good!

Title: Re: Kaiju Build Done
Post by: Paul Birkeland on February 15, 2018, 07:02:36 PM

That's quite the hefty load box you have there!

Title: Re: Kaiju Build Done
Post by: bombay317 on February 19, 2018, 03:52:05 AM

Haha, yes it is super oversized power wise, but I grabbed what was easily available and made 8 ohms. Then I just wired them and put them in a project box.

Even at max power output from the amp at 8W, that would be 2W per resistor. There is margin for sure.