Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Seduction => Topic started by: undertowogt on July 27, 2010, 11:57:48 AM

Title: Simple question Regarding Part 10 Step 1,Passive RIAA
Post by: undertowogt on July 27, 2010, 11:57:48 AM

Hi
I am close to being done my first build, almost there except for 1 question (hopefully)

I have a Simple question Regarding Part 10 Step 1,Passive RIAA. The instructions state...

Quote " Slip a 1-14" piece of teflon tubing over one lead of a Megohm resistor (1004F)."

The current kti does not come with Teflton, was this the old way of doing it in a past kit? Did they forget to add a revision on the revision page I was sent (with other instruction revisions).

I have teflon tape I used to make DIY cables a while ago, woudl that work?

Any thoughts?
Thanks in advance for the replys.

RT

Title: Re: Simple question Regarding Part 10 Step 1,Passive RIAA
Post by: Doc B. on July 27, 2010, 12:35:04 PM

you don't really need the teflon, so we no longer include it.

Title: Re: Simple question Regarding Part 10 Step 1,Passive RIAA
Post by: undertowogt on July 27, 2010, 12:40:32 PM

Thanks for the reply. I guess I will trust your judgement Doc :)
BTW the kit is great

Title: Re: Simple question Regarding Part 10 Step 1,Passive RIAA
Post by: Paul Birkeland on July 27, 2010, 07:21:53 PM

You can use a piece of wire jacket from the supplied teflon coated wire.

Title: Re: Simple question Regarding Part 10 Step 1,Passive RIAA
Post by: undertowogt on July 28, 2010, 12:08:12 AM

Quote from: Caucasian Blackplate on July 27, 2010, 07:21:53 PM

You can use a piece of wire jacket from the supplied teflon coated wire.

I was thinking of that too. I wasnt sure if the outer (black)
 casing was teflon though. i guess it is