Bottlehead Forum

Bottlehead Kits => Stereomour II => Topic started by: d_composer on November 02, 2017, 05:37:32 PM

Title: DC Filament Supply question [resolved]
Post by: d_composer on November 02, 2017, 05:37:32 PM

I’m nearing the end of the DC Filament Supply mod install and I’m at the instruction to “attach and solder the twisted pair of wires formerly attached to 22L and 24L to the AC holes on the ciruit board closer to the A side” and then the other pair of wires go to the D side. What sides are these? I don’t see an A or D on the pcb. What side is this instruction referring to? Thanks!

Title: Re: DC Filament Supply question
Post by: fullheadofnothing on November 02, 2017, 05:58:12 PM

Sockets. Same as in Stereomour manual.

Title: Re: DC Filament Supply question
Post by: d_composer on November 03, 2017, 01:38:31 AM

Thanks! Built the Stereomour too long ago to remember the socket letter nomenclature!

Title: Re: DC Filament Supply question
Post by: d_composer on November 03, 2017, 04:48:42 AM

Got it working - WOW!!!! Sounds amazing!!! ;D