Bottlehead Forum
Bottlehead Kits => S.E.X. Kit => Topic started by: wylymon on May 24, 2017, 07:19:18 PM
-
The DACT did not come with instructions and I have not
found any help on line. The DACT came with an optional
wiring option that allowed solderless connection
by a Molex type connector to the six pins on the DACT.
I can't figure out how to wire the DACT. Any help would
be really appreciated.
James Wyly
-
Set your meter to DC resistance, then turn the volume control all the way down.
There should be two pairs of pins that show almost 0 DC resistance between them. One pin from each set is ground, the other is signal + out.
Turn the volume control all the way up. There should now be two different pins that show almost 0 DC resistance between them. One pin from each set is signal + out, the other pin is signal + in.
Since signal out is present in both sets of measurements, process of elimination will give you ground and signal + in.
-PB