Bottlehead Forum

General Category => General Discussion => Topic started by: sharethemusic on March 07, 2018, 07:48:47 AM

Title: 300b input set up pre out?
Post by: sharethemusic on March 07, 2018, 07:48:47 AM

hi,i just received a pre built 300b bottlehead..no manual..no instructions... which set of inputs is for pre out to mu amplifier...regards andy

Title: Re: 300b input set up pre out?
Post by: bombay317 on March 07, 2018, 08:16:54 AM

Are there markings on the underside of the metal where all the electronics are?  They should be labelled with Right and Left Inputs and Outputs.

Title: Re: 300b input set up pre out?
Post by: Chris65 on March 07, 2018, 10:10:55 AM

If you mean the BeePre 300B Pre-Amp, then the output is from the two sets of jacks at the back right - XLR's and RCA jacks in the standard configuration. The three sets of RCA jacks inboard are the inputs.

So, left to right: Input 3, Input 2, Input 1, Output 1 (RCA) Output 2 (XLR)

Quote from: bombay317 on March 07, 2018, 08:16:54 AM

They should be labelled with Right and Left Inputs and Outputs.

Why would they be? Up to the builder whether they are labelled or not. ;)