Bottlehead Forum
Bottlehead Kits => Crack => Topic started by: RSMaxwell on April 28, 2018, 11:15:25 PM
-
I'm getting lazy in my old age, so I'm just asking rather than texting or doing a in depth search...
What is the Crack's output impedednce/load? (120 Ohm?)
What is the Crack's output amperage?
What is the Crack's output voltage?
-
What is the Crack's output impedednce/load? (120 Ohm?)
That's about right. It will depend a little bit on the specific 6080 (or 5998) used for testing.
What is the Crack's output amperage?
+/- 30mA peak to peak.
What is the Crack's output voltage?
This is extremely dependent on the load the Crack sees. I don't think you'll get much more than 13V RMS out into any load.