Bottlehead Forum

Bottlehead Kits => S.E.X. Kit => Topic started by: roycruz23 on May 10, 2018, 12:21:12 PM

Title: Stock Potentiometer knob
Post by: roycruz23 on May 10, 2018, 12:21:12 PM

The stock potentiometer on S.E.X. 3.0 looks cool. I am looking at upgrading it to a Goldpoint attenuator.
Does the stock knob gonna fit into Goldpoint? Any suggestions for a replacement knob? I will appreciate your reply.

Title: Re: Stock Potentiometer knob
Post by: Adrian on May 10, 2018, 11:58:18 PM

Yes, it fits.

I had to notch out an area in the box for the attenuator to fit.

Title: Re: Stock Potentiometer knob
Post by: Paul Birkeland on May 11, 2018, 04:43:00 AM

Our pots and rotary switch all use a 1/4" shaft (I'm 99% sure on that at least).  The Goldpoints are 6mm.  What this means is that the stock knob will fit on a Goldpoint pot, but a Goldpoint knob won't fit on our parts without being drilled out slightly (1/4" is about 6.3mm).

Title: Re: Stock Potentiometer knob
Post by: roycruz23 on May 12, 2018, 06:34:52 PM

Thank you! you are very helpful. I don't have to buy another knob then.