Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Crack-a-two-a => Topic started by: Warmaster Horus on January 29, 2020, 12:08:37 PM

Title: Mislabeled PT-8 transformer?
Post by: Warmaster Horus on January 29, 2020, 12:08:37 PM

Hello!
I am building a crack-a-2-a, my 2nd BH kit (did a crack + speedball a few years ago).

I'm at the step to wire up the power transformer (after checking mains voltage), and while i followed the label on the transformer when installing it onto the plate, it now looks like the label may be flipped?
(Where pins 1-6 are labeled, there are only 3 terminals, etc).

I have posted a photo of the transformer in my kit:

https://imgur.com/gallery/e6s4Hf7

It looks like the label is just upside down, but can anyone take a look and confirm that it looks correct otherwise?
(Just want a 2nd set of eyes/opinion before i proceed..)

Thank you!

Title: Re: Mislabeled PT-8 transformer?
Post by: Paul Birkeland on January 29, 2020, 12:13:50 PM

Yes, the sticker needs to be flipped around. (the transformer does too)