Bottlehead Forum
Bottlehead Kits => Bottlehead Power Cord Kit => Topic started by: Jimb0 on March 30, 2020, 03:09:11 PM
-
Tested the continuity but I'm getting 0.001 for all three pins
I set my voltometer to AC/2v like in the picture
Is this okay?
-
That's the wrong end of the knob you're looking at. It's pointing to the continuity setting in the ohms scales at about 7:30 rather than the 2VAC scale at 1:30. If you don't have a continuity beeper on your meter you can just use your lowest ohms scale.
-
perfect thanks Doc! I got 0.3 ohms for each reading
-
Sounds like you're good to go.