Bottlehead Forum
Bottlehead Kits => Crack => Topic started by: lycos on November 06, 2020, 04:54:18 PM
-
Hi,
I have just finished building crack.
I have done the resistance and voltage test.
The sound only comes on right channel. No sound on left channel.
I have reflowed every joint but the problem still persists.
How do I find the source of this issue?
Thanks.
-
Can you post your voltages on terminals 1-10?
I don't suppose you're using a 1/4" to 1/8" adapter?
-
Thanks for prompt reply.
Will do the voltage test again
Yes, Im using 3.5mm to 6.35mm adapter.
I dont think there’s issue with adapter because its working fine when i
plugged it to my solid state amp
-
Can you post your voltages on terminals 1-10?
I don't suppose you're using a 1/4" to 1/8" adapter?
1. 86.3
2. 178
3. 0
4. 178
5. 80.6
6. 0
7. 119
8. 0
9. 109
10. 0
-
I would very, very, very strongly suggest trying a pair of headphones without the adapter. There are a few varieties of those adapters that don't work all that well. We used to keep a bin of them on the wall at the old office because we would have to throw them away so frequently.
-
I would very, very, very strongly suggest trying a pair of headphones without the adapter. There are a few varieties of those adapters that don't work all that well. We used to keep a bin of them on the wall at the old office because we would have to throw them away so frequently.
I found the issue, the foot of 3k 10w resistor was slightly loose and missed during resoldering.
Its all working now.
Thank you!!