Bottlehead Forum

Bottlehead Kits => Crack => Topic started by: andyh on December 08, 2020, 11:34:12 AM

Title: Extra wire??
Post by: andyh on December 08, 2020, 11:34:12 AM

How do i go about getting extra wire?? can't see any purchase options.

Title: Re: Extra wire??
Post by: Paul Birkeland on December 08, 2020, 11:35:15 AM

You would need to e-mail replacementparts(at)bottlehead(dot)com.

We provide more than enough wire to construct the kit, so if you've run out I would be a little surprised.

Title: Re: Extra wire??
Post by: andyh on December 08, 2020, 11:38:40 AM

Ok thank you, just that I'm a novice at this and thought spare may allow for the odd mistake. :)

Title: Re: Extra wire??
Post by: Deluk on December 09, 2020, 12:32:30 AM

I had some bits and pieces left over. Didn't have to change anything. I would say though that if you braid the 3 wires from the inputs to the pot tightly the cutting lengths in the manual are a bit short IMO. I would add another inch to the three to make routing around the pot terminals easier. Comments from the team welcome.

Title: Re: Extra wire??
Post by: andyh on December 09, 2020, 01:25:59 AM

Thanks for the tip.