Bottlehead Forum
Bottlehead Kits => Legacy Kit Products => Stereomour => Topic started by: InfernoSTi on November 23, 2010, 04:41:55 AM
-
I thought I would post some of my instruction notes for any of the other novice builders who may find this helpful. I have to say, the quality of the instructions were much, much higher than I ever expected and this is an easy build if you are methodical and don't rush things!
Page 45: red wire to Power Transformer T15 (not T12) on 6.3 v heater wiring.
Page 45: black wire to 10L (not 8L). This is shown in later photos (page 61) but not mentioned. It helps when trying to stuff drain wires into 8L later.
Page 61 On 2-1/4" STP, strip 1/2" off 'clipped' drain wire end (not 1-1/2"). Later references use the correct length.
There, that's it! Not bad for an 80 page manual, not bad at all. :-)
Cheers, John