Bottlehead Forum

Bottlehead Kits => Stereomour II => Topic started by: peterq on April 10, 2021, 11:15:30 AM

Title: How to adjust 10ohm pot?
Post by: peterq on April 10, 2021, 11:15:30 AM

Hi,
Sorry about two many entry level questions, I see there are two 10ohm pot on each 2a3, in document the name is Rhumpot, may I ask how to adjust these two pot? Thanks.

Peter

Title: Re: How to adjust 10ohm pot?
Post by: Paul Joppa on April 10, 2021, 11:30:43 AM

It's in the manual, page 67. It's also a sticky post in this forum.

Put an AC voltage meter on an output, adjust pot for  lowest voltage. Repeat on other channel.

Title: Re: How to adjust 10ohm pot?
Post by: peterq on April 10, 2021, 09:13:20 PM

Thank you Paul. I understand the method.