Bottlehead Forum

Bottlehead Kits => Stereomour II => Topic started by: lesouthern on April 15, 2021, 03:51:58 PM

Title: voltage check new stereomour build
Post by: lesouthern on April 15, 2021, 03:51:58 PM

Hi-

Doing a voltage check.

Getting 0 VDC on 6, 21, 24, 25. All others are normal.

I assume this is a bad solder, outside of the places showing the wrong reading, any suggestions on where else to look?

thanks

-Larry

Title: Re: voltage check new stereomour build
Post by: Paul Birkeland on April 15, 2021, 07:05:02 PM

I would just post build photos.  It's very likely that you're missing a connection in order for that to be possible.

Title: Re: voltage check new stereomour build
Post by: lesouthern on April 16, 2021, 06:00:14 AM

found it, was missing L1 -> A2 connection.

thanks