Bottlehead Forum
Bottlehead Kits => Stereomour II => Topic started by: thoven0215 on April 28, 2022, 12:55:13 PM
-
The manual calls for a 365 ohm metal film resistor, and I did not have a resistor that looked at all like the one in the manual. I measured my resistors, and there was one that measured at 365 ohms. I attached a picture of the one I found that measured at 365 ohms. I also attached a picture of what it is in the manual. It is the dull orange color with black writing on it. Further, if my resistor is the right one, which side goes to where or does it not matter? Thanks.
-
These are non directional parts. Due to supply chain issues, it is inevitable at this point that there will be some parts in your kit that look a little different than what's in the manual.
-
Ah ok, thank you for your help.