Bottlehead Forum

Bottlehead Kits => Crack => Topic started by: gmony911 on May 03, 2022, 10:09:13 AM

Title: Troubleshooting Speedball upgrade - failed resistance checks [resolved]
Post by: gmony911 on May 03, 2022, 10:09:13 AM

Installing the crack upgrade.

The small circuit board was installed and passed all voltage checks.

The larger circuit board is not showing any resistance readings between 12U and OA, and between 12U and OB.

I've attached some images of the top and bottom of the board. Appreciate any troubleshooting tips.

Title: Re: Troubleshooting Speedball upgrade - failed resistance checks
Post by: Paul Birkeland on May 03, 2022, 10:10:41 AM

What reading does your meter give?  (Your photos didn't come through)

Title: Re: Troubleshooting Speedball upgrade - failed resistance checks
Post by: gmony911 on May 03, 2022, 10:13:24 AM

Zero. Tried adjusting the scale across options as well.

Retrying pics attachment

Title: Re: Troubleshooting Speedball upgrade - failed resistance checks
Post by: gmony911 on May 03, 2022, 10:17:54 AM

Sorry shows OL

Title: Re: Troubleshooting Speedball upgrade - failed resistance checks
Post by: Paul Birkeland on May 03, 2022, 10:22:05 AM

OK, zero is zero and OL means "Over limit" which is what the manual specifies as a correct reading.

Title: Re: Troubleshooting Speedball upgrade - failed resistance checks
Post by: gmony911 on May 03, 2022, 10:40:21 AM

Thank you. The upgrade is done and is working well.