Bottlehead Forum

Bottlehead Kits => S.E.X. Kit => Topic started by: wylymon on January 22, 2011, 06:45:33 PM

Title: Problems installing a DACT attenuator on the SEX
Post by: wylymon on January 22, 2011, 06:45:33 PM

Trying to install the little devil on the SEX top plate. The attenuator has small protrusions on the bottom
that do not allow it to sit flat and snug on the backside of the top plate. I don't want to try to file them
off. Anyone tried to put this attenuator on the SEX ?  Suggestions are really needed.

Thanks

James Wyly, Rapid City, SD

Title: Re: Problems installing a DACT attenuator on the SEX
Post by: Paul Joppa on January 22, 2011, 08:20:58 PM

The protrusions are there to prevent the control from rotating. The DACT instructions include a diagram (or you can find it on their web site) - basically you have to slightly enlarge the hole, and expand the existing key hole to a slot. A couple files will do the job if you are patient.

Title: Re: Problems installing a DACT attenuator on the SEX
Post by: wylymon on January 24, 2011, 02:16:19 AM

Thank you Paul!

James Wyly