Bottlehead Forum

Bottlehead Kits => BeePre => Topic started by: blackharp on March 03, 2023, 06:09:18 AM

Title: Bee Pre 2 Selector Switch
Post by: blackharp on March 03, 2023, 06:09:18 AM

Is it possible to overheat a point in the selector switch (like the power switch I melted)? I notice on one terminal, it isn't quite as sturdy, but seems fine, just nervous after melting a power switch. I would hate to get to a point and have to re-solder all those wires there. Not sure if there is a way to test terminal 3 from page 46?

Title: Re: Bee Pre 2 Selector Switch
Post by: Paul Birkeland on March 03, 2023, 07:40:13 AM

You'll have to test all the inputs when the preamp is complete.  If they are all working but a terminal is a little wiggly, you can drip just one small drop of super glue onto it (not the gel kind) to keep it from moving around.

Title: Re: Bee Pre 2 Selector Switch
Post by: blackharp on March 03, 2023, 09:20:09 AM

Thank you!