Bottlehead Forum

Bottlehead Kits => BeePre => Topic started by: hpleung on February 17, 2024, 05:20:27 AM

Title: Resistance check is 0
Post by: hpleung on February 17, 2024, 05:20:27 AM

I am doing my first resistance check with the beepree.

The terminal 8 vs terminal 1 is yielding 0; like it is not connected.

Is there any pointers on where i should look?

Note: terminal 8 and terminal 16 yield 4.5 ohm.

Title: Re: Resistance check is 0
Post by: hpleung on February 17, 2024, 05:21:33 AM

Attached pic

Title: Re: Resistance check is 0
Post by: Paul Birkeland on February 17, 2024, 06:54:42 AM

See the second to the last step on page 35 of the manual.  Also be sure you didn't accidentally do the same thing on the other side.

Title: Re: Resistance check is 0
Post by: hpleung on February 17, 2024, 08:41:57 AM

Thank you that was it. I have a generic question.

The instruction says go terminal 8 then 9.

Electrically if you went to 9 then 8; does it make a difference?

Similarly, if the instruction says connect to L and you connect to U; does that make a difference

Of course i am following the instructions to the letter but i wanted to know if it makes a differences.

Title: Re: Resistance check is 0
Post by: Paul Birkeland on February 17, 2024, 09:36:58 AM

That doesn't make a difference electrically.