Bottlehead Forum

General Category => General Discussion => Topic started by: Leftistelf on May 24, 2025, 08:04:23 AM

Title: Fuse for Crack 1.1 - I don’t understand
Post by: Leftistelf on May 24, 2025, 08:04:23 AM

Hi everyone,

I’m building the Crack 1.1 for the first time, and after I install the IEC, the instructions are to put the fuse in the fuse holder before testing the AC switch for the first time. I have the provided fuse, but I can’t find a fuse holder anywhere. What am I missing?

Thanks!

Title: Re: Fuse for Crack 1.1 - I don’t understand
Post by: Paul Joppa on May 24, 2025, 09:21:17 AM

It's part of the IEC power inlet socket.

Title: Re: Fuse for Crack 1.1 - I don’t understand
Post by: Paul Birkeland on May 24, 2025, 10:04:13 AM

The picture on page 23 shows the fuse in the fuse holder, which slides out of the IEC power entry module. If it won't slide out, there's a hole on the back that you can use to give it some motivation.