Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Stereomour => Topic started by: drewh1 on March 20, 2013, 07:18:12 PM

Title: Assembly instructions discrepancy
Post by: drewh1 on March 20, 2013, 07:18:12 PM

on the Active load Circuit board - the assemply instructions (pg. 24/25) where you connect -reg to bA show 2 holes on bA and bB. My circuit board has 3 holes on these pads. I assume these are all connected and it doesn't matter which two I use?

Title: Re: Assembly instructions discrepancy
Post by: rlyach on March 20, 2013, 07:24:17 PM

Yes, I believe they are all shorted. You can use your ohm meter to check. I just used two next to each other and left the one closest to the center of the board open.

Title: Re: Assembly instructions discrepancy
Post by: drewh1 on March 20, 2013, 07:35:21 PM

Thanks, good to know I am not the only crazy hanging around this forum at 10:30!

Title: Re: Assembly instructions discrepancy
Post by: Grainger49 on March 21, 2013, 12:06:38 AM

Drew,

There are a lot of crazies here.  Have you checked my Corner?

Title: Re: Assembly instructions discrepancy
Post by: drewh1 on March 21, 2013, 05:26:56 AM

Yep - that is kind of what convinced me I belong here.