Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Quickie => Topic started by: willspeed on April 04, 2013, 06:58:08 AM

Title: Quickie 1.1/PJCCS Question
Post by: willspeed on April 04, 2013, 06:58:08 AM

Hey guys,

I'm looking at the Quickie manual on page 20 - and by looking at the pictures, shouldn't step 4 on this page state to wire from B2 to 6L?

Thanks,

Will

Title: Re: Quickie 1.1/PJCCS Question
Post by: 4krow on April 04, 2013, 09:27:00 AM

If I read the schematic correctly, tube pins 2,4,6 are the same electrically. Is that the question you are asking?

Title: Re: Quickie 1.1/PJCCS Question
Post by: Magnetron on April 16, 2013, 05:49:23 PM

I went with pin 6 on both tubes, for uniformity.

Title: Re: Quickie 1.1/PJCCS Question
Post by: Paul Birkeland on April 16, 2013, 06:02:53 PM

No, the wire should be run as indicated.

If you install the PJCCS, this will aide in installation.

-PB