Bottlehead Forum

Bottlehead Kits => Eros Phono => Topic started by: azrockitman on August 06, 2013, 08:11:12 PM

Title: Twin Plate load/servo pc boards-construction tip
Post by: azrockitman on August 06, 2013, 08:11:12 PM

I'm curious if there is a strong consensus on whether to build both boards at the same time, or build one, then the other. 

Logic leads me to construct both boards simultaneously, since they are twins.  If I'm carefully following instructions, it seems like the chance for error would be lower by completing each step twice simultaneously; conversely I would think the chance for error higher if I was needing to read through those same instructions on two different occasions. 

Thanks

Title: Re: Twin Plate load/servo pc boards-construction tip
Post by: Grainger49 on August 06, 2013, 11:17:34 PM

I built one at a time.  I think I took 6 or 7 short build evenings to build my Eros.  It was relaxing doing just a little at a time.  BTW, I built completely stock to begin with then after 2 months tried some capacitor rolling with jumpers.

Title: Re: Twin Plate load/servo pc boards-construction tip
Post by: Doc B. on August 07, 2013, 05:55:12 AM

The chance for making the same error twice is much higher.

Title: Re: Twin Plate load/servo pc boards-construction tip
Post by: azrockitman on August 07, 2013, 10:05:45 AM

Looks like it's unanimous.   :)  One at a time it is. Thanks