Bottlehead Forum

General Category => General Discussion => Topic started by: tuffy_puppy on February 12, 2014, 03:51:00 AM

Title: source switch
Post by: tuffy_puppy on February 12, 2014, 03:51:00 AM

good morning all,  does anyone know of a switch that would allow one to run two sources into one set of speakers?  a very favorite set of speakers is awaiting such a switch.  suggestions?  ideas?  not a preamp.  thanks, don

Title: Re: source switch
Post by: Paul Birkeland on February 12, 2014, 06:20:58 AM

You can use an A/B speaker switch, but wire it backwards.

Just be sure to measure with your meter that both + and - on the disconnected side read open in reference to the + and - on the connected side.

-PB