Bottlehead Forum

Bottlehead Kits => BeePre => Topic started by: docbob52 on May 28, 2014, 01:46:12 PM

Title: BeePre died again
Post by: docbob52 on May 28, 2014, 01:46:12 PM

My BeePre died yesterday   No sound on both channels  now after sounding so wonderful for many months.  Both 300B tubes not fully lightening up now--only a small glow at the top.  What do I need to check now?   My past experience is that I had to re-solder the pins which I did when one channel went missing in action. That worked then,  but I doubt both tubes went bad here at the same time after only 140 hours.


 All advise appreciated.

Title: Re: BeePre died again
Post by: Paul Birkeland on May 28, 2014, 06:46:05 PM

Post voltages.