Bottlehead Forum
General Category => Technical topics => Topic started by: JamieMcC on October 25, 2014, 02:39:47 AM
-
I am pondering over trying a couple of small switches in the signal path to switch between a little resistor attenuation and none. Having just tried adding a couple of resistors to get some more range whilst using the headphone this worked well but its knocked back the volume via the speakers more than I would like.
On my next mouser order I will add a few different values to try only having a couple of RN55 270k to hand and finding they where a little to much attenuation.
Also wondering if it is possible to attenuate only the head phone out at the socket somehow? Any thoughts, suggestions welcome?
-
You can attenuate the output with an L-pad; it will of course limit the maximum output. For details, post the question under the appropriate product so that the discussion can be more easily located by others in the future.
-
If you're referring to the SEX amp, I would use the impedance switch kit to the same effect.
-PB
-
If you're referring to the SEX amp, I would use the impedance switch kit to the same effect.
-PB
I was and never thought of doing that probably because its still in the kit box I have been enjoying the Sex so much I haven't got round to fitting it yet thanks PB, PJ.