Bottlehead Forum

Bottlehead Kits => Legacy Kit Products => Stereomour => Topic started by: Jim R. on December 19, 2014, 02:14:07 PM

Title: Some simple questions about Stereomour...
Post by: Jim R. on December 19, 2014, 02:14:07 PM

Hi folks,

Just a few simple questions:

For those with 2a3 stereomours, how hot does your plate choke get? I have been planning on putting the plate shoke in a transformer cover and I want to make sure this won't cause any problems.

Second question: is it ok to use aluminum standoffs for the power supply board instead of plastic ones?

That's it, see, simple.

Thanks,

Jim

Title: Re: Some simple questions about Stereomour...
Post by: Daikini on December 21, 2014, 04:37:06 AM

The plate chokes on my stereomour get a little warm, but not hot.

Title: Re: Some simple questions about Stereomour...
Post by: Jim R. on December 21, 2014, 08:34:40 AM

Thanks much -- I'm going to go ahead and use the covers.

I also got an answer to my other questionm, and for the curious, yes, it is ok to use aluminum standoffs for the PS board.

-- Jim

Title: Re: Some simple questions about Stereomour...
Post by: galyons on December 21, 2014, 09:46:21 AM

I prefer to use plastic/nylon as they are non-conductive. I did use aluminum for the Crack, but I encased them in heat shrink tubing.

Cheers,
Geary