Bottlehead Forum
General Category => Tech Tools => Topic started by: audiomaniac on March 12, 2015, 07:19:53 AM
-
What is a good flux cleaner to have on your workbench when working with PCBs, such as the Speedball? Thanks
-
I use the Isopropyl alcohol wipes I get with my syringes.
-
I use the Isopropyl alcohol wipes I get with my syringes.
That sounds simple enough. I saw some stuff on Amazon that I thought would be good, but I want to make sure it's safe to use on a board.
-
I use grain alcohol purchased from the ABC store. I was trained to solder in a NASA 40 hour course in 1972 and that is what they used. It smells good and if you are so inclined you can have a sip.
-
I use grain alcohol purchased from the ABC store. I was trained to solder in a NASA 40 hour course in 1972 and that is what they used. It smells good and if you are so inclined you can have a sip.
I did some training myself with all kinds of alcohol when I was younger............. ::)
-
"Turns out that there weren't as many redundant systems in the Space Shuttle as we thought. We were just seeing double."
-
I've always used 99.9% isopropyl alcohol, not to be confused with the grain alcohol suggested earlier. Do NOT drink isopropyl alcohol, you'll likely end up in the ER. Not that I haven't landed in the ER after drinking ethyl(grain) alcohol before..
I don't know about a bottle of Everclear or a mason jar of granpda's medicine but isopropyl in liberal amounts rubbed over the messy area with something like a q-tip or kim wipe is perfectly safe for your boards. If it's a particularly bad mess or dirty board you can also get anti-static brushes on Amazon, but for something like the speedball you probably don't need that. Isopropyl typically does the job very well and quickly evaporates.
This is what I use:
http://www.amazon.com/MG-Chemicals-Isopropyl-Alcohol-Cleaner/dp/B008UH4AI8/ref=sr_1_5?ie=UTF8&qid=1432191635&sr=8-5
-
For those of us who are diabetic, and get alcohol wipes along with syringes, they work well too. They are also great for rubbing out touch ups on your car.
-
My take on this is that you really shouldn't need to clean flux off the boards we sell. I'd suggest trying a different brand of solder if you have excess flux on the board. And maybe practice on getting just enough, and not too much, solder on the pads. A smaller tip might help too.
-
Yeah for all of the BH soldering I have done so far I don't believe I've ever needed to clean the flux. Usually when I need to clean flux it's for a chip or something where I had to apply some flux to make it easier.
-
My gripe with cleaning flux is that you have to get absolutely all of it off, otherwise it leaves a sticky residue that looks kinda nasty.
-
It may be a tongue in cheek type of thing, but some of the de-soldering braid that I use leaves a real mess. In that case, I will resort to acitone.
-
I've found that too as there is some flux in the stuff. IPA all the way for me, but as PB pointed out it can leave a sticky trail so usually i have to clean boards twice to get it 100%.
Also worth mentioning that the flux crud can be slightly conductive and cause havoc on sensitive circuits, thats a good reason alone to clean it off. It also tends to turn black with heat inside a tube amp.